Looking for pump design simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Centrifugal pump designed for Sudanese ventilator project

Common negative-pressure pump as is used for hand soap and hand sanitizer.

Try to simulate the easiest version of a ram pump

In this project I study the effects of use of different inlet shapes on the performance of a centrifugal pump. A generic centrifugal pump was designed as the core for the analysis.
It consists of a stator part, rotor and virtual rotating zone. The inlet section of the pump is extended and three shapes are investigated: straight intake, single 90 deg turn and double 90 deg turn. Keeping the operating conditions of the pump constant the investigation was focused on rotation driven flow (fluid motion is generated only by the pump). The comparison of difference in obtained flow rate and the observable differences in flow representation was presented.

The objectives are to sequentially optimise the impeller and case design using the results of the previous iterations and to then gain the performance curves and understand how cavitation might affect the design.

pump design | SimScale Project Library | Page 1